Notifiche
Cancella tutti

My prints  

  RSS
robin.s
(@robin-s)
Eminent Member
My prints

Some prints. Among other a picam cover

Postato : 05/03/2017 12:12 am
robin.s
(@robin-s)
Eminent Member
Topic starter answered:
Re: My prints

Picam

Postato : 05/03/2017 12:15 am
robin.s
(@robin-s)
Eminent Member
Topic starter answered:
Re: My prints

What will be a slider with a stepper motor and a belt controling it (i hope)

Postato : 05/03/2017 12:17 am
robin.s
(@robin-s)
Eminent Member
Topic starter answered:
Re: My prints

Finished slider, just waiting on some electronics stuff that I ordered for it

Postato : 07/03/2017 6:25 pm
robin.s
(@robin-s)
Eminent Member
Topic starter answered:
Re: My prints

Had a hard time getting the right tension on the Y belt, so I made a tensioner for it

Postato : 07/03/2017 8:07 pm
herve.t
(@herve-t)
Active Member
Re: My prints

nice work! 😎

Postato : 07/03/2017 9:30 pm
robin.s
(@robin-s)
Eminent Member
Topic starter answered:
Re: My prints

Drumstick holder ment to sit on the base of an electronic drum foot

Postato : 29/03/2017 4:26 pm
robin.s
(@robin-s)
Eminent Member
Topic starter answered:
Re: My prints

Small spool for ninjaflex filament sample

Postato : 29/03/2017 4:27 pm
robin.s
(@robin-s)
Eminent Member
Topic starter answered:
Re: My prints

Servo setup for pi camera so it can look around

the large white base is a chunk of steel to get some weight to it, not 3d printed

Postato : 29/03/2017 4:28 pm
robin.s
(@robin-s)
Eminent Member
Topic starter answered:
Re: My prints

A test with NinjaFlex

Postato : 29/03/2017 7:11 pm
Army Chief
(@army-chief)
Active Member
Re: My prints

What settings do you use on the Ninjaflex? I've had to slow mine down a lot slower than I thought would be necessary to print ninjaflex. I sliced it with max speeds at 15 mm/s and still had to drop the feedrate below 70% before I was completely jam free. Before that I'd hit a jam anywhere between the 2nd layer and 1.5 hours into the print.

Chief

Postato : 06/04/2017 6:48 am
Condividi: