Multimaterial Upgrade Test Prints
 

Multimaterial Upgrade Test Prints  

  RSS
PJR
 pjr
(@pjr)
Moderator

Needs to be cleaned up a little, but a nice print.

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…...
Posted : 26/01/2017 4:13 pm
marc.s
(@marc-s)
Trusted Member

How long did it take to print it in comparison to the one colour Adalinda?

...
Posted : 26/01/2017 4:24 pm
PJR
 pjr
(@pjr)
Moderator

Cheshire Cat

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…...
Posted : 26/01/2017 10:00 pm
patrick.s13
(@patrick-s13)
Eminent Member

Those are awesome ! Thanks for sharing !

...
Posted : 15/02/2017 3:43 pm
herve.t
(@herve-t)
Active Member

the cat is splendid! 😎

...
Posted : 15/02/2017 5:17 pm
john.c13
(@john-c13)
New Member

Alice in the Wonderland! I love this kitty. Thanks for sharing, nice work!

...
Posted : 19/02/2017 11:15 pm
PJR
 pjr
(@pjr)
Moderator

Here's a few articulated snakes:

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…...
Posted : 20/02/2017 10:54 am
PJR
 pjr
(@pjr)
Moderator

6 x 3 colour Aria

Poor quality; I messed up, sliced with wrong settings (0.25 layer height, 0.5 width, way too fast). Needed to go out and forgot to change settings from previous slice - didn't realise until I returned.

Still, 11 hours 52 minutes, so not bad on time.

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…...
Posted : 06/03/2017 9:06 am
3Delight
(@3delight)
Moderator

Looking good, can't wait for the kit to finally come out!

It's about time the Filament companies got their acts together when it comes to the quality (width and 'blobs') as it holds back development, costs everyone more money and work, and needs some sort of standards (one of those ISO xxxx or IEEEE xxxx ratings or something).

Posted : 11/03/2017 9:03 pm
PJR
 pjr
(@pjr)
Moderator

It's about time the Filament companies got their acts together when it comes to the quality (width and 'blobs') as it holds back development, costs everyone more money and work, and needs some sort of standards (one of those ISO xxxx or IEEEE xxxx ratings or something).

Yes, +1 on that. It happens with most filament providers though (including PR), but the 1.85mm limit on the current setup is too tight a tolerance.

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…...
Posted : 14/03/2017 1:19 pm
Share:

Please Login or Register