Medieval Castle - Rainbow  

  RSS
stevensmith
(@stevensmith)
Trusted Member

I am very happy with how this rainbow filament castle came out on my 3 week old MK3S kit. The model can be found on Thingiverse:
https://www.thingiverse.com/thing:2581233

Sliced in PrusaSlicer at .2mm layer height, the print took 45 hours and 41 minutes. Filament is Stronghero Splendid rainbow PLA.

  

This topic was modified 3 months ago by stevensmith
Posted : 26/12/2019 3:11 am
KestrelStudios(tm), aperlik2, toma.i2 and 3 people liked
larry.r
(@larry-r)
Active Member

Wow, that turned out fantastic. Did you use supports?

Posted : 03/01/2020 2:41 pm
stevensmith
(@stevensmith)
Trusted Member

@larry-r

No supports needed!

Posted : 03/01/2020 2:58 pm
david.a66 liked
Peter
(@peter13)
New Member

Wow! Impressive job and quality 🙂

 

Best regards!
https://3dwork.io

Posted : 04/01/2020 10:01 am
Robert-mm200
(@robert-rmm200)
Noble Member

Sure beats changing filaments for the colors!

(Your kit may be three weeks old - but you have more experience than that with 3D printers. Kids - don't try this at home until you have a few miles under your belt.)

This post was modified 3 months ago by Robert-mm200
Posted : 04/01/2020 5:59 pm
stevensmith
(@stevensmith)
Trusted Member

@robert-rmm200

That is good advice!

Posted : 07/01/2020 6:43 am
gnasher666
(@gnasher666)
Active Member

Epic print

Posted : 17/02/2020 6:52 pm
stevensmith
(@stevensmith)
Trusted Member

@gnasher666

Thank you! 

Posted : 18/02/2020 2:13 am
Share:

Please Login or Register