Notifications
Clear all

Finally working!  

  RSS
augustin.b
(@augustin-b)
New Member
Finally working!

So I got my printer for my birthday and started assembling it. After I was done it was time for calibration and that took AGES! kept getting error messages, I damaged the bed but after all of that it was working 😀 I got a few prints with it but my Print head leaked so I tightened it... at the wrong place... and ended up breaking the heat break after 2 days of having it 😐 After waiting 9 days to get parts, I assembled it back together only to find out that for some reason my x carriage didn't reach the end stop and it would just keep going left without stopping and jumping steps on the steppers. That was caused by bad cable management and causing the x carriage not to reach the end stop. after fixing that I calibrated it... again and it is working marvelously! I love it and I am now in the process of printing myself a phone case! :mrgreen: :mrgreen:

Posted : 26/04/2017 7:43 am
JeffJordan
(@jeffjordan)
Member Moderator
Re: Finally working!

➡ welcome !

💡 reading about your teething troubles, you're quite right here at the forum. :mrgreen:

dem inscheniör is' nix zu schwör...

Posted : 26/04/2017 1:44 pm
Share: