30hrs in and the textured build plate is still working well
 
Notifications
Clear all

30hrs in and the textured build plate is still working well  

  RSS
TheSameNameTwice
(@thesamenametwice)
New Member
30hrs in and the textured build plate is still working well

This build plate just works fantastically! Only thing I've done to clean the bed in the 30+ hours is take a microfiber cloth to it after the bed is warmed up for the next print. I did have issues with PLA sticking at first but I just upped the build plate temperature by 5 degrees from the default and made sure my Z was a little lower than I normally would.  I'll keep y'all updated once I hit 100+ hours.

Posted : 10/09/2019 4:19 pm
DarkTeck 3D, Nigel, bobstro and 1 people liked
Share: