Notifications
Clear all

Kisslicer and PrusaMini?  

  RSS
Stefan
(@stefan-2)
New Member
Kisslicer and PrusaMini?

Before I start from scratch, has somebody some settings for PLA to save me time and filament?

Thanks,
s.

Posted : 13/01/2020 1:10 pm
richard.l
(@richard-l)
Member Moderator
RE: Kisslicer and PrusaMini?

@PJR is the KISS guru. Hopefully he sees this thread.

Posted : 13/01/2020 1:50 pm
Stefan
(@stefan-2)
New Member
Topic starter answered:
RE: Kisslicer and PrusaMini?

very disappointing ... Kisslicer produced a very fine chep calibration cube with the default settings and support turned off. No tweaking, head-scratching and throwing-hands-up-in-frustration required 😎 

So I copied the prefix gcode from a PrusaSlicer print to get the bed leveling, replaced temperatures with appropriate variables and that's it for now.

Of course I won't be able to resist tweaking speeds here and there, but KISS basically worked very well out of the box. Good for KISS and good for the Mini.

 

Posted : 16/01/2020 5:34 pm
nuggetz
(@nuggetz)
Eminent Member
RE: Kisslicer and PrusaMini?

Bump. 

Is there a good Cura profile out? I dont feel like tweaking start/end gcode. Prusa has links on the mini page for S3D and Cura but if you follow the links they are only for MK2/3 🙁

I know the printer hasn't been out long but it would be nice to have some decent support. They dont even have a published nozzle replacement doc for the mini yet.

Posted : 11/02/2020 5:03 pm
Share: