Avisos
Vaciar todo

Cura vs PrusaSlicer?  

  RSS
cronhelm
(@cronhelm)
New Member
Cura vs PrusaSlicer?

I have been using Cura for a while and am pretty familiar with it.  Just purchased a Prusa Mini and am wondering if I should continue w Cura or switch over to PrusaSlicer?

Just saw a youtube video comparing printing speeds and it seemed to say that Cura based print took more than twice as long as the PrusaSlicer based print.  

Respondido : 16/02/2020 9:13 pm
bobstro
(@bobstro)
Illustrious Member
RE: Cura vs PrusaSlicer?

Be sure to compare actual print times and not slicer estimates. If the hardware settings aren't correct for the printer (e.g. acceleration, jerk) estimates can be way off.

Cura is a good slicer and under heavy development. It has some interesting capabilities and if you like it, there's no reason to switch. That said, PrusaSlicer is also under heavy development, and is tuned for the Prusa printers. Support may be easier if you post here with PrusaSlicer settings.

My notes and disclaimers on 3D printing

and miscellaneous other tech projects
He is intelligent, but not experienced. His pattern indicates two dimensional thinking. -- Spock in Star Trek: The Wrath of Khan

Respondido : 16/02/2020 9:21 pm
Compartir: