outside bits are getting knocked off of mask print
 
Notifications
Clear all

outside bits are getting knocked off of mask print  

  RSS
dave.95graham
(@dave-95graham)
New Member
outside bits are getting knocked off of mask print

hello all, I have been printing the visors out using my mk3s printer, and the bits on the outside that connect to the outside that allow several visors to be printed on top of each other keep getting knocked over/off (like in the picture)

is there anything i can do to prevent this? i have cleaned the plate with with glass cleaner and covered with a bit of talcum powder so the print stays on ok (it has for the rest of it) but these little bits keep getting knocked off ruining the print. is there any solutions for this?

i have also added the print settings I am using as it improves the print quality. i have been using amazon basic PETG, which has a recommended print heat of 230C-250C  and we have just received some of the prusa filament in the post today so wanting to try that out asap.

TIA

David

 

Posted : 07/05/2020 1:37 pm
Share: