Mask print - Mid-layer Shift
 

Mask print - Mid-layer Shift  

  RSS
simon.j3
(@simon-j3)
New Member

Panic. I does anyone know what might be causing this layer slip mid print? Everything was working fine with PLA. This is my 3rd attempt with PETG - the 1st was good and the 2nd had a slight slip, this one is obviously unacceptable. I'm trying PLA again to see if this is machine or material related, but in the meantime, does anyone have any suggestions?

Posted : 21/04/2020 7:30 am
itanc
(@itanc)
New Member

i am getting this on 2 printers and have noticed it always happens on the layer above the ‘Prusa’ logo. I am using ctc a10 printers and PLA. It’s all quite new to me so if you have any insights I would welcome them

 

Posted : 29/04/2020 5:51 pm