Face Shield Hole Measurement
 
Notifications
Clear all

Face Shield Hole Measurement  

  RSS
Andrew
(@andrew-3)
New Member
Face Shield Hole Measurement

Hey Guys,

I'm trying to make some face shields. I have 8 RC3 pieces and I'm having trouble with hole spacing. I have wasted a couple of sheets trying to figure it out. Does anyone know how far apart the holes need to be or a printable cutout page for an 8.5 x 11 sized sheet?

 

Thank you!!

Posted : 31/03/2020 3:44 pm
Bob H
(@bob-h)
Active Member
RE: Face Shield Hole Measurement

im in the same boat no one answering

Posted : 04/04/2020 7:08 pm
kennd
(@kennd)
Reputable Member
RE: Face Shield Hole Measurement

https://www.prusaprinters.org/prints/27950-prusa-protective-face-shield-rc3-us-version

 

Quality is the Journey, not the Destination. My limited prints->

Posted : 05/04/2020 12:27 am
kennd
(@kennd)
Reputable Member
RE: Face Shield Hole Measurement

make sure you printed the US version.

check  https://blog.prusaprinters.org/from-design-to-mass-3d-printing-of-medical-shields-in-three-days/ here for entry for the Prusa face shield info.

Quality is the Journey, not the Destination. My limited prints->

Posted : 05/04/2020 12:28 am
Bob H
(@bob-h)
Active Member
RE: Face Shield Hole Measurement

checked that link it is not the same as I have printed I got the sheet from the uk and it was pre drilled and profiled but it has 4 holes like my model but don't fit

 

Posted : 05/04/2020 4:56 pm
Jakub Geyer
(@jakub-geyer)
Active Member
RE: Face Shield Hole Measurement

I designed this one. It fits the EU version. Careful about the print orientation (flip it before printing). The two lines of 4 are for normal/extended version, the 3 holes are for bottom part.

https://forum.prusa3d.com/forum/coronavirus-covid-19/wider-visor-shape-drawing/#post-205163

Posted : 05/04/2020 5:21 pm
Share: