Avisos
Vaciar todo

PINDA Setup question  

  RSS
Marc
 Marc
(@marc-3)
Active Member
PINDA Setup question

Issue: I have been running the setup Wizard after a nozzle change. When the 4 calibration points process is running, my nozzle contacts the paper at Point 1. I have shut off the machine and reran the Wizard four times. After checking my PINDA height in relation to the nozzle, see included picture, I'm wonder what I missed. 

Configuration:

Printer: Prusa i3 MK3S assembled by myself

Deviations from standard: None. Standard 4 mm nozzle, PRUSA PLA filament, PRUSA slicer

Case description:

The machine can't complete the setup wizard without touching the paper. 

Slicer: N/A

Filament used: N/A

Printer setup: standard

Print setup: no enclosure, sits on a shelve in the basement. Temp 73 F and 37% humidity.

Attach files: N/A

Coincidence: I just performed a nozzle change 

Respondido : 26/10/2020 9:56 pm
--
 --
(@)
Illustrious Member
RE: PINDA Setup question

You must read the instructions. They explain what you must do to keep the nozzle from scraping.  Too long to reproduce here. But those Z lead screws must be turned to adjust for the bed conditions.

And - the PINDA looks much too high -- too far from the bed. Desired height is 0.8 mm to 1.2 mm (I'd have to look it up).

Esta publicación ha sido modificada el hace 4 years 2 veces por --
Respondido : 26/10/2020 10:31 pm
Marc
 Marc
(@marc-3)
Active Member
Topic starter answered:
RE: PINDA Setup question

Thank you Tim. 

 

In following your advice to lower the PINDA sensor, it seems to have addressed the issue. 

 

Thank you

Marc

Respondido : 26/10/2020 11:51 pm
-- me gusta
Compartir: