Y Belt Idler issue  

  RSS
Loopman
(@loopman)
New Member

I started my build today however, I never got very far. The Y belt Idler or the front plate has the holes in the wrong place. The distance between the holes and the front plate and the holes on the plastic piece are different distances apart. The printer is the MK3S+ and I am following the manual V3.21 supplied with the printer.

Posted : 02/01/2021 9:56 pm
karl-herbert
(@karl-herbert)
Illustrious Member
Posted by: @loopman

I started my build today however, I never got very far. The Y belt Idler or the front plate has the holes in the wrong place. The distance between the holes and the front plate and the holes on the plastic piece are different distances apart. The printer is the MK3S+ and I am following the manual V3.21 supplied with the printer.

I suspect that Prusa has sent you a wrong part. I would take a photo of both parts and contact the Prusachat (Log in with your account and select the eshop. adblocker should be disabled).

Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen....
Posted : 02/01/2021 11:19 pm
Loopman
(@loopman)
New Member

@karl-herbert

Thanks I will try that tomorrow.

Posted : 02/01/2021 11:24 pm
Share:

Please Login or Register