Notifications
Clear all

y axis problem  

  RSS
tw007
(@tw007)
New Member
y axis problem

Help, when I try to print, my printer does the 9 point calibration but then it rises up to about 4 inches, goes to the right and stops 3 inches from the right.

Posted : 18/10/2021 9:24 am
BogdanH
(@bogdanh)
Honorable Member

You will need to tell more than that to get some help. How old is printer? You printed successfully before? You tried to print some different object? etc.etc. In short: we know nothing about your situation.

[Mini+] [MK3S+BEAR]...
Posted : 18/10/2021 11:41 am
tw007
(@tw007)
New Member
Topic starter answered:
Trouble with first print

Hi,  Sorry it's the X axis I'm I am a fist starter with 3D printers, My printer is a brand new MK3S+  kit . My issue is, It does a 9 point check and then it rises and travels to the end of the x axis and not the Y axis, then it stops.

Set up  -  Preheat PLA,  Autoload Filament at 215/60,   print from SD   Stops at end of X axis and not the Y Axis. it beeps to press the knob to unload the filament.     and that's it    (  it did not do the self test where it lays beads of filament ).

Posted : 19/10/2021 2:49 am
Share: