Notifications
Clear all

Wobbely Mini+  

  RSS
Rien
 Rien
(@rien)
Active Member
Wobbely Mini+

I just received and assambled my Mini+, the problem is that it's 'wobbely'.

I put 4 foam-pads on the XZ-axis as shown in the manual and the YouTube instructions.

The problem is with the 5th foam-pad. It sits under the electronic-box but it's not on the same level with the other foam-pads. So, my printer is not stable.

Posted : 04/05/2021 3:08 pm
mrstoned
(@mrstoned)
Estimable Member
RE: Wobbely Mini+

I had a similar problem when removing the buildplate that it would lift the whole printer towards the rear and right.

I printed and put https://www.prusaprinters.org/prints/44643-prusa-mini-power-plug-stress-relief and now it is rock solid.

 

I guess it depends a little on how the bridging is on the slot for the foampad on the electronics box.

Tevo Nereus.
Prusa Mini+ kit. BondTech extruder....
Posted : 05/05/2021 11:41 am
Rien
 Rien
(@rien)
Active Member
Topic starter answered:
RE: Wobbely Mini+

@mrstoned

Thanks for this solution. I will print it this weekend (my first print!) and hope it's the solution.

Posted : 05/05/2021 1:36 pm
cwbullet
(@cwbullet)
Illustrious Member
RE: Wobbely Mini+

@mrstoned

Great addition.  I will also print this tonight.  V

--------------------
Chuck H
3D Printer Review Blog...
Posted : 05/05/2021 5:11 pm
Share: