Very high first layer Z on new Mini  

  RSS
graham.l2
(@graham-l2)
Active Member

Hi

I have just assembled my new mini and the Z level is very high (or is that low) to get the correct first layer cal  -1.95

As its factory set should I jump in and adjust the PINDA height or be looking at somthing else first?

Thanks

Graham

Posted : 15/09/2020 7:52 pm
Karl Herbert
(@karl-herbert)
Famed Member
Posted by: @graham-l2

Hi

I have just assembled my new mini and the Z level is very high (or is that low) to get the correct first layer cal  -1.95

As its factory set should I jump in and adjust the PINDA height or be looking at somthing else first?

Thanks

Graham

Hello and welcome to the Prusaforum!

I would adjust the MINDA - look here: https://help.prusa3d.com/en/guide/troubleshooting-the-mini-assembly_7848/ (STEP 2)!

Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen....
Posted : 15/09/2020 7:55 pm
graham.l2
(@graham-l2)
Active Member

@karl-herbert

Ok thanks Karl (MINDA eh ! Ive still got my 3i head on 🙂

Graham

 

Posted : 15/09/2020 7:58 pm
graham.l2
(@graham-l2)
Active Member

That sorted it.

The manufacturers setting of the MINDA probe was set about 1mm to low.

Graham

Posted : 17/09/2020 7:11 pm
Share:

Please Login or Register