Notifications
Clear all

New Printer Issues 🙁  

  RSS
BigguyUK
(@bigguyuk)
New Member
New Printer Issues 🙁

Hi Guys 

Hope somebody can help 

I Got my Prusa Mini yesterday Built it no Problem 

But can i get it to do the calibration print 🙁

Had issues with the filament to start with and found it was coming out of the feeder with ridges so slackened this off 

See Pic i just cannot get a consistent calibration print

Can anybody point me in the right direction

Posted : 03/06/2020 6:54 pm
Crawlerin
(@crawlerin)
Prominent Member
RE: New Printer Issues 🙁

Your Z offset is too high, lift nozzle up a bit.

Also, just in case, check if the XZ axis is perpendicular to bed, if one side is not higher that the other. X gantry should be as parallel to bed as possible. Release and tighten 3 screws used in assembly to make it square.

Posted : 04/06/2020 12:35 pm
BigguyUK
(@bigguyuk)
New Member
Topic starter answered:
RE: New Printer Issues 🙁

Hi Many thanks sorted it 

Gantry Wasd level

Thanks to youtube Reset Pinda Probe

as i had to move heater block up

Insert a longer PTF Tube 

and did a New calibration 

See the results 🙂

Looks ok so far 

Posted : 04/06/2020 5:39 pm
Crawlerin liked
yophosis
(@yophosis)
Active Member
RE: New Printer Issues 🙁

The smooth PEI steel sheet grabs the filament much better for me than the textured steel sheet.

Posted : 10/06/2020 8:36 pm
Share: