Notifications
Clear all

mmu won't load filament  

  RSS
TechTiger
(@techtiger)
Eminent Member
mmu won't load filament

I've been printing on this unit a while (although the MMU is extremely problematic) but about 2 months ago, I had an issue and I felt it best to recalibrate the printer from the beginning like a new build.   I get passed the calibration points but then it asks to load filament in tube 1 of the MMU.  The selector does its thing going to the right then back, then it will select #1 then error out and flash red.  I have checked the filament path from the mmu through the festo tube and its perfectly clean.  The selector never goes to #1 or start loading the filament.  Then it will error out with RED/GREEN lights.  Resetting the mmu will start it over again but it fails every time.  No filament will ever load to do anything.  

Any thoughts on why this isn't working?   I'm wondering if my selector motor may have died.

Posted : 13/01/2020 10:42 pm
Olef
 Olef
(@olef)
Prominent Member
RE: mmu won't load filament

Think you're in the wrong forum Eric. This is Prusa MINI only...

Posted : 13/01/2020 11:08 pm
TechTiger
(@techtiger)
Eminent Member
Topic starter answered:
RE: mmu won't load filament

Oh crap. Yes I am.  Mods please delete and accept my appologies

Posted : 13/01/2020 11:56 pm
Share: