Notifications
Clear all

[Solved] left side bad print  

  RSS
geert
(@geert)
Active Member
left side bad print

hello,

got a  prusa mini and started printing
every print on the right side is ok but wen it starts to print on the left side of the printerbed it goes wrong

every time at the same place

does  this sound familiar ?

idea's

gr geert

 

Napsal : 10/04/2021 2:05 pm
Turro75
(@turro75)
Estimable Member
RE: left side bad print

https://help.prusa3d.com/en/article/xz-axis-skew-correction-mini_158518

Napsal : 10/04/2021 2:44 pm
geert
(@geert)
Active Member
Topic starter answered:
RE: left side bad print

thanks, will try this as soon as possible
Gr geert

Napsal : 10/04/2021 3:29 pm
Diem
 Diem
(@diem)
Illustrious Member
RE: left side bad print

@geert

But first give the print bed a thorough clean in case it's just a patch of fingerprints ruining adhesion at that point.

Cheerio,

Napsal : 10/04/2021 7:12 pm
geert
(@geert)
Active Member
Topic starter answered:
RE: left side bad print

hey,

it is not only the first layer
it is the complete print up till the end

would like to show  a picture, but  can not get it on this forum

 

gr geert

Napsal : 10/04/2021 7:28 pm
Diem
 Diem
(@diem)
Illustrious Member
RE: left side bad print
Posted by: @geert

would like to show  a picture, but  can not get it on this forum

Use 'Add Media' at top of form.

Cheerio,

 

Napsal : 11/04/2021 7:31 am
geert
(@geert)
Active Member
Topic starter answered:
RE: left side bad print

thanks

Napsal : 11/04/2021 12:12 pm
Diem
 Diem
(@diem)
Illustrious Member
RE: left side bad print

@geert

every print on the right side is ok but wen it starts to print on the left side of the printerbed it goes wrong

every time at the same place

Do you mean every time you print this part? or every print you make?

What happens if you rotate the print, or move it to a different part of the bed?

Cheerio,

 

Napsal : 11/04/2021 4:18 pm
geert
(@geert)
Active Member
Topic starter answered:
RE: left side bad print

hey hey ,

 

it was every print i made and yes it is solved

thanks torro75, it took only a few minutes

 

greets and thanks all

geert

Napsal : 12/04/2021 10:20 am
Share: