Notifications
Clear all

Filament leakage  

  RSS
JF
 JF
(@jf)
New Member
Filament leakage

Hello All

I recently bought Prusa MINI and I encounter some problem. During printing I have a leak of filament between heaterblock and heatbreak. It takes a while but eventually huge blob is created and drops on print ruining it (printing head hits it and it starts huge mess). I asked how heaterblock and heatbreak are sealed (if there is any sealant) but nobody could answer me. I checked all dimensions (heaterblock from radiator 3,8mm, nozzle from heatbreak 0,5mm, nozze is touching the heatbreak for sure), made many trials but it is still the same. Has anyone encounter this problem and has a solution?

Posted : 03/08/2020 1:10 pm
Zane
 Zane
(@zane)
Eminent Member
RE: Filament leakage

Sounds like its not put together properly, solution would be to follow the steps to change the heatbreak, remove it and assemble again.

...
Posted : 11/08/2020 1:39 pm
Share: