Notifications
Clear all

Colorisation with transparant filament  

  RSS
Oxygen
(@oxygen)
Reputable Member
Colorisation with transparant filament

What can cause these 'colorization' effects in the bottom?

Best Answer by John Doe:

Had same issue. Problem is that any additional layer on existing layer makes the transparency less and less visible. Had to print it one layer on sides that should be transparent. Mine was a statue of a woman.

Mini with FW:4.4.1 + SuperPINDA + Bondtech Heatbreak + PC4-M8 couplers + 1 piece boden

Posted : 17/05/2020 7:04 pm
John Doe
(@john-doe-3)
Estimable Member
RE: Colorisation with transparant filament

Had same issue. Problem is that any additional layer on existing layer makes the transparency less and less visible. Had to print it one layer on sides that should be transparent. Mine was a statue of a woman.

Posted : 18/05/2020 7:26 am
Oxygen
(@oxygen)
Reputable Member
Topic starter answered:
RE: Colorisation with transparant filament

I'll try, thank you

Mini with FW:4.4.1 + SuperPINDA + Bondtech Heatbreak + PC4-M8 couplers + 1 piece boden

Posted : 18/05/2020 7:46 am
Crawlerin
(@crawlerin)
Prominent Member
RE: Colorisation with transparant filament

Would this help?

 

Posted : 20/05/2020 12:03 am
Share: