Notifications
Clear all
Changed to .25 nozzle with extruder problems
This is my first try at a different nozzle diameter.
I just changed my nozzle from .4 to .25 and the extruder started clicking almost immediately. I have LOTS of experience having to cold pull the mini (cheap filament). However, I'm using Hatchbox PLA for the .25 prints so I shouldn't have an issue there, at least not immediately. I was trying to get the first layer calibrated by printing a 3inch square. I did remember to set the nozzle to .25, chose the .15 quality profile, and remembered to use the Mini .25 nozzle profile.
Is there something else I should have done? A setting I've missed?
Brian
Posted : 27/11/2021 8:49 am