Notifications
Clear all
Wirlybird
Wirlybird
Group: Registered
Joined: 2016/10/07
Reputable Member
5
I'm running a MK2.5s so I think I am on the older LA. I am ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Thanks for the info. I asked about the steppers since it is ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Hi all, just found this so jumping in. I have an original ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
VFA's (Vertical Fine Artifacts) After MK2 to MK2.5s Upgrade....

In forum Hardware, firmware and software help

2 years ago
I am a bit embarrassed but I did solve this!I have a line in...

In forum Assembly and first prints troubleshooting

2 years ago
MK2.5s Upgrade Issue With Vertical "Banding/Lines" On Print ...

In forum Assembly and first prints troubleshooting

2 years ago
I think they are the same. Reason I think this is that if y...

In forum Hardware, firmware and software help

2 years ago
MK2 to MK2.5s Upgrade Seems To Be Over-Extruding

In forum Assembly and first prints troubleshooting

2 years ago
@clemens-m That's ok. I wasn't implying doing it on the boa...

In forum Hardware, firmware and software help

4 years ago
Ok so let's circle back to the begging on converting the MK2...

In forum Hardware, firmware and software help

4 years ago
@clemens-m Good question and I'll clarify! My stock setup wo...

In forum Hardware, firmware and software help

4 years ago
So I found several DC-DC 12v to 24v step up converters on Am...

In forum Hardware, firmware and software help

4 years ago
@clemens-m Wiring the external mosfet to run the heater is n...

In forum Hardware, firmware and software help

4 years ago
@clemens-m Thanks. What if I ran a separate mosfet for the h...

In forum Hardware, firmware and software help

4 years ago
Convert MK2 to 24 volt?

In forum Hardware, firmware and software help

4 years ago
Just to Clarify MK2.5s PINDA Operation

In forum Hardware, firmware and software help

5 years ago
MK2.5s Upgrade - PINDA Preheat?

In forum Hardware, firmware and software help

5 years ago
Same problem on a new MK2.5s build. Part cooling fan comes ...

In forum Hardware, firmware and software help

5 years ago
Wow! Really appreciate the effort!

In forum General discussion, announcements and releases

5 years ago
Bare MK2 Heat Bed without LED or Resistor?

In forum Hardware, firmware and software help

5 years ago
Page 1 / 15
Share: