Vojtěch
Vojtěch
Group: Registered
Joined: 2019/01/01
Honorable Member
1
I bought the garolite (textite) sheets cut to size locally a...

In forum Hardware, firmware and software help

1 month ago
I'm using a bare (no magigoo or any spray) Garolite sheet wi...

In forum How do I print this? (Printing help)

4 months ago
@toblanc34 The Mk3 comes with an all-metal E3D hotend, the P...

In forum How do I print this? (Printing help)

4 months ago
Yes. Funssor bearing holders. They may need to be cut a litt...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
I've installed almost all of what's available from Funssor i...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
The good news is: The E3D v6 that is shipped with the Mk3S i...

In forum Hardware, firmware and software help

1 year ago
If it's just about the surface, then stainless-steel filled ...

In forum General discussion, announcements and releases

1 year ago
Plast-I-Weld is reported to be based on Dichloromethane. Be ...

In forum How do I print this? (Printing help)

1 year ago
What issues did the Mosquito solve for you? Just wondering: ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
That is exactly what the verification pass of avrdude is abo...

In forum Hardware, firmware and software help

1 year ago
@tim-m30 I understand this post is pointless, as you've alre...

In forum Hardware, firmware and software help

1 year ago
By the way, I tried slicing your part and if you cut about a...

In forum Hardware, firmware and software help

1 year ago
It should be noted, though, that the printer aligns the two ...

In forum Assembly and first prints troubleshooting

1 year ago
The 1.1mm distance has never worked for me, even when I buil...

In forum Assembly and first prints troubleshooting

1 year ago
Great, that's progress. Your next problem is solved easily: ...

In forum Assembly and first prints troubleshooting

1 year ago
Well yes, assuming you're testing without the flex PEI sheet...

In forum Assembly and first prints troubleshooting

1 year ago
I checked the avrdude sources to see what 'checksum error' m...

In forum Hardware, firmware and software help

1 year ago
Yes, the PTFE chamfer also explains the shapes better to me....

In forum Assembly and first prints troubleshooting

1 year ago
@nick-i3mk3s Where does the thick part of the removed filame...

In forum Assembly and first prints troubleshooting

1 year ago
So it was necessary to disassemble the hot-end. If I also ac...

In forum Assembly and first prints troubleshooting

1 year ago
Page 1 / 32
Share:

Please Login or Register