vintagepc
vintagepc
Group: Registered
Joined: 2018/12/29
Noble Member
3
Not necessary, vesconite bushings are already impregnated wi...

In forum User mods - OctoPrint, enclosures, nozzles, ...

16 hours ago
Why not just write a simple gcode script with the same comma...

In forum General discussion, announcements and releases

22 hours ago
Weird. 95% of the time the sensors are the cause. You must b...

In forum Hardware, firmware and software help

2 days ago
This still looks exactly like what you get if the part is wa...

In forum Hardware, firmware and software help

2 days ago
Certainly a lot easier with a skelestruder than stock since ...

In forum How do I print this? (Printing help)

2 days ago
I'd just assumed that installing one would necessitate adjus...

In forum How do I print this? (Printing help)

2 days ago
If you're interested in a hardware tweak, you can buy "adapt...

In forum How do I print this? (Printing help)

2 days ago
Your IR sensor/tower is not set correctly. It's probably stu...

In forum Hardware, firmware and software help

3 days ago
(Have you tried running one of the magnets from your 3S extr...

In forum Hardware, firmware and software help

3 days ago
Your bed is also dirty/contaminated, I can see streaking in ...

In forum Assembly and first prints troubleshooting

3 days ago
I have an MMU2S, have done quite a few prints on it and have...

In forum Assembly and first prints troubleshooting

4 days ago
might be of interest to you.You could extend it to let you c...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 days ago
Why were they seized? Were they full of junk (e.g. filament ...

In forum Assembly and first prints troubleshooting

4 days ago
^^ What he said. Filament simply cannot "tangle" from the f...

In forum Hardware, firmware and software help

4 days ago
I think it's more that they don't want to paint themselves i...

In forum Improvements (Archive)

5 days ago
there should NOT be thermal paste on your nozzle or in the h...

In forum Hardware, firmware and software help

5 days ago
Yeah - SD is dead simple and fairly lightweight to read with...

In forum Improvements (Archive)

5 days ago
Those are the cooling moves for the tip shaping. If you look...

In forum PrusaSlicer

5 days ago
I've found the failure of the selector to home can easily co...

In forum Hardware, firmware and software help

5 days ago
The 2h sheep is a bit misleading. The actual model is printe...

In forum PrusaSlicer

6 days ago
Page 1 / 76
Share:

Please Login or Register