Prusa3D Forum

Notifications

Clear all

tompjagiello

Groupe: Enregistré

A(ont) rejoint: 2020/05/16

Active Member

	Yes, I've gone back to the original Prusa heatbreak and all ... Dans le forum Assembly and first prints troubleshooting	il y a 1 year
	Really hard to say as you've also changed the extruder, so i... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	So do you currently have the Bondtech heatbreak installed in... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	@bdudelsack did you ever get this resolved? I'm battling the... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	I'm definitely having issues with this. Normally I run Z-axi... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	how tight should the belts be? Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	To fix uneven layers I'd suggest checking the bolts that hol... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	first layers oversized and uneven in "vase" mode Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Hi Rick, I wasn't aware it's enabled by default, just checke... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Question for people experimenting with these on the Prusa Mi... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Oh finally some activity in this topic 😳 Btw Prusa's suppor... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Bulging corners Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Had a similar issue, I did my first layer calibration on a s... Dans le forum General discussion, announcements and releases	il y a 4 years
	So I've been doing loads of tests recently, printing loads o... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Hi Sylvain, I'm in a similar boat, also noticed that my prin... Dans le forum Assembly and first prints troubleshooting	il y a 4 years

Statistiques du forum

535 Forums

59.6 K Sujets

427.1 K Messages

13 En-ligne

64 K Membres

Le dernier des messages: print with pellets not filament Notre nouveau membre: Charles Jacques Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé