Activity
 
Notifications
Clear all
toby.k
toby.k
Group: Registered
Joined: 2016/11/16
Trusted Member
3
I will post when the case is released. I’m making final twe...

In forum Awesome prints (Hall Of Fame)

5 years ago
I really like that case, it has an awesome retro vibe - I co...

In forum Awesome prints (Hall Of Fame)

5 years ago
Serious Mini Server / NAS Case

In forum Awesome prints (Hall Of Fame)

5 years ago
I am also running into a similar issue with ASA on my MK3. ...

In forum Assembly and first prints troubleshooting

5 years ago
I assume that's PLA .. If you've already tried a different ...

In forum General discussion, announcements and releases

5 years ago
How hot do you push your printer enclosure?

In forum General discussion, announcements and releases

6 years ago
Well done, both the print and your photos. What filament and...

In forum Awesome prints (Hall Of Fame)

6 years ago
I've been toying with this idea for a few weeks.... Order a...

In forum General discussion, announcements and releases

6 years ago
If the bed has cooled, that's when the PEI really grabs hold...

In forum How do I print this? (Printing help)

6 years ago
I've never had/seen those issues on my Mk2s or Mk3... howev...

In forum General discussion, announcements and releases

6 years ago
Not to get off topic with the PLA issue, but... I'm trying t...

In forum Assembly and first prints troubleshooting

6 years ago
The other way around the serial baud rate limit is to use a ...

In forum General discussion, announcements and releases

6 years ago
Had a similar issue on my Mk2. Turned out to be a damaged w...

In forum General discussion, announcements and releases

6 years ago
I have the same problem on my MK3. I have a Flash Air card ...

In forum Hardware, firmware and software help

6 years ago
I would order an extra of both fans...I have had the worst l...

In forum General discussion, announcements and releases

6 years ago
That might be an extrusion or retract issue. Try these two ...

In forum General discussion, announcements and releases

6 years ago
Best 3d printed razor scraper handle ever...Not sure the pla...

In forum General discussion, announcements and releases

6 years ago
Zach, Have you tried these yet? I just ordered a set from A...

In forum General discussion, announcements and releases

6 years ago
Page 2 / 4
Share: