Notifications
Clear all
timothyebuchanan
Group: Registered
Joined: 2020/03/27
Active Member
1
|
Interesting. So half say detergent and half alcohol. I have ... In forum Hardware, firmware and software help |
4 years ago | |
|
Problem with PEI sheet In forum Hardware, firmware and software help |
4 years ago | |
|
Never mind. Realized you can't change these settings until y... In forum PrusaSlicer |
4 years ago | |
|
Can't make changes to support material settings in PrusaSlic... In forum PrusaSlicer |
4 years ago | |
| @area51 Tomorrow I will try loosening the back carriage fast... | 4 years ago | |
| Self test failed on X axis: why? | 4 years ago | |
| @mar-15 Any ideas on when it will be back in stock? | 4 years ago | |
| @towlerg The Zero takes longer to boot than the RPi3 used wi... | 4 years ago | |
| @nilok Yes, I had placed pins with board components on outsi... | 4 years ago | |
| @nilok It's a zero w. | 4 years ago | |
| OctoPi works, but not when plugged into MK3S | 4 years ago | |
| @joantabb Good to know. Thanks. | 4 years ago | |
| Thanks; I didn't realize just how much of a live Z adjustmen... | 4 years ago | |
| New MK3S. First layer not sticking | 4 years ago |