Activity
 
Tim
Tim
Group: Registered
Joined: 2018/09/10
Illustrious Member
Following up on Zoltan's comments. The printer has no absolu...

In forum General discussion, announcements and releases

8 hours ago
I suggest it is far easier for you to post a photo or three ...

In forum General discussion, announcements and releases

9 hours ago
For slowing down those last few layers, here are a couple se...

In forum General discussion, announcements and releases

9 hours ago
X and Y - when powered off - should move to the limits very ...

In forum Hardware, firmware and software help

13 hours ago
Try adjusting the direction the fan shroud points. And add a...

In forum Hardware, firmware and software help

13 hours ago
Depending on how you have things connected - USB vs direct -...

In forum Hardware, firmware and software help

13 hours ago
The thermistor is a standard E3D variety. Prusa or E3D adju...

In forum Hardware, firmware and software help

13 hours ago
As Neo said, the part design is unprintable without supports...

In forum How do I print this? (Printing help)

14 hours ago
The colon in the filename is the issue for us Win7 users.

In forum How do I print this? (Printing help)

14 hours ago
I've been hosed by firmware updates too many times to count,...

In forum General discussion, announcements and releases

14 hours ago
My computer is telling me the 3MF is corrupt ...

In forum How do I print this? (Printing help)

15 hours ago
And make sure the belt drive gears are properly installed: i...

In forum Assembly and first prints troubleshooting

15 hours ago
Light goes off when the PINDA detects metal. Slide a screwd...

In forum Assembly and first prints troubleshooting

15 hours ago
@mdaneman - what you describe is often caused not by the fir...

In forum General discussion, announcements and releases

15 hours ago
Before doing ANY mechanical work, please do check the tip of...

In forum General discussion, announcements and releases

15 hours ago
If you are using Windows, and don't have a dedicated GPU (nV...

In forum PrusaSlicer

15 hours ago
Resolution while slicing. In two axes the model is - for the...

In forum PrusaSlicer

2 days ago
Also - if while just sitting there the ambient nozzle temp r...

In forum Assembly and first prints troubleshooting

2 days ago
One other easy check: when it jams up, do a simple UNLOAD a...

In forum General discussion, announcements and releases

2 days ago
There is a firmware bug that if the filament sensor is enabl...

In forum General discussion, announcements and releases

2 days ago
Page 1 / 251
Share:

Please Login or Register