|
Any way to change display to time remaining instead of time ... In forum Hardware, firmware and software help |
1 year ago |
|
You don't need a dedicated computer for Octoprint - at least... In forum General discussion, announcements and releases |
2 years ago |
|
If you open the image of the OP, you can see the connections... In forum User mods - OctoPrint, enclosures, nozzles, ... |
2 years ago |
|
Prior request here: In layer material change In forum PrusaSlicer |
3 years ago |
|
I just opened a new feature request to eliminate the need to... In forum PrusaSlicer |
3 years ago |
|
Sorry for not seeing this before. If you inspect your gcode... In forum PrusaSlicer |
3 years ago |
|
I had tried this before but failed because I was editing the... In forum PrusaSlicer |
3 years ago |
|
Thanks for all the suggestions and tips. I particularly fou... In forum PrusaSlicer |
3 years ago |
|
How to make User Presets Sticky and Locally Shared In forum PrusaSlicer |
3 years ago |
|
Been using the Bondtech for over a year now (forum.prusa3d.c... In forum User mods - OctoPrint, enclosures, nozzles, ... |
3 years ago |
|
@kennd Thanks for asking. I just did it by hand. Not a big... In forum PrusaSlicer |
3 years ago |
|
Another option that makes the original much easier to load. ... In forum User mods - OctoPrint, enclosures, nozzles, ... |
3 years ago |
|
The resistor does, in fact, reduce the brightness as you sur... In forum User mods - OctoPrint, enclosures, nozzles, ... |
3 years ago |
|
..and do check out the instructions from B&B. I was laz... In forum User mods - OctoPrint, enclosures, nozzles, ... |
3 years ago |
|
@newshockerguy Zero issues since July 2019 and it is indispe... In forum User mods - OctoPrint, enclosures, nozzles, ... |
3 years ago |
|
@bobstro "Just to be clear: You're asking for use with semi-... In forum PrusaSlicer |
3 years ago |
|
@neophyl Will do. I have submitted a couple there already b... In forum PrusaSlicer |
3 years ago |
|
Feature Request: Color change except perimeters In forum PrusaSlicer |
3 years ago |
|
Would you mind sharing exactly what path you changed it to? ... In forum Hardware, firmware and software help |
3 years ago |
|
Indeed it does! I was on 2.1. Thanks! In forum PrusaSlicer |
3 years ago |
