Activity
 
sw3De
sw3De
Group: Registered
Joined: 2019/08/18
Trusted Member
3
I have often wondered how much it really matters if it’s +/-...

In forum General discussion, announcements and releases

4 months ago
@charles-h13 Nice, but don’t expect too much, I guess there ...

In forum General discussion, announcements and releases

4 months ago
Oh, I should try to explain why I choose a cable cutter but ...

In forum General discussion, announcements and releases

4 months ago
One tool I have used for almost 6 years now and I have never...

In forum General discussion, announcements and releases

4 months ago
Are you sure your stl is good? Maybe it’s not watertight? If...

In forum How do I print this? (Printing help)

4 months ago
You could try to lower the temp and print speed, more fan. J...

In forum How do I print this? (Printing help)

4 months ago
@ron I liked those graphs a lot, thanks for sharing and plea...

In forum General discussion, announcements and releases

4 months ago
An easy test to do to see if the sounds are from vibrations ...

In forum Hardware, firmware and software help

5 months ago
I have used Buildtak’s PEI sheets on their flexplates for ov...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 months ago
Awesome, Thank you! This will definitely go to my to do list...

In forum General discussion, announcements and releases

5 months ago
@peter-m26 That's a nice one!Do you know of any software to ...

In forum General discussion, announcements and releases

5 months ago
@claire-k Thats a great project, maybe a little too time con...

In forum General discussion, announcements and releases

5 months ago
Looking for a new project

In forum General discussion, announcements and releases

5 months ago
@ernelli-m Then we're almost neighbors, I live in Undenäs, i...

In forum How do I print this? (Printing help)

5 months ago
@ernelli-m Thanks for your response. Good points! May I ask ...

In forum How do I print this? (Printing help)

5 months ago
@neophyl Adding more perimeters made it look good in PS just...

In forum How do I print this? (Printing help)

5 months ago
I would definitely go for epoxy and no sanding. FWIW If you ...

In forum How do I print this? (Printing help)

5 months ago
@neophyl I will post a picture tomorrow, if I can find it. I...

In forum How do I print this? (Printing help)

5 months ago
Oh, using PS 2.2.0+

In forum How do I print this? (Printing help)

5 months ago
Problems with bridge infill. Model snaps at that point when ...

In forum How do I print this? (Printing help)

5 months ago
Page 2 / 3
Share:

Please Login or Register