|
First Layer Issue with Front Right Corner of the Print Bed In forum Assembly and first prints troubleshooting |
1 year ago |
|
I will try this, thanks! In forum Hardware, firmware and software help |
4 years ago |
|
It is a total blockage and I feAr it could be in the heat br... In forum Hardware, firmware and software help |
4 years ago |
|
...and now I have a clicking clog. Have my acupuncture need... In forum Hardware, firmware and software help |
4 years ago |
|
I am still looking for 91+% alcohol...it’s not immediately a... In forum Hardware, firmware and software help |
4 years ago |
|
@zoltan I did a full soak in Dawn saturated water after a sc... In forum Hardware, firmware and software help |
4 years ago |
|
Ah! Smooth is what I have. In forum Hardware, firmware and software help |
4 years ago |
|
@joantabb Ok, my error. I thought PEI and powder coat were ... In forum Hardware, firmware and software help |
4 years ago |
|
I was hesitant to use acetone because I didn’t want to ruin ... In forum Hardware, firmware and software help |
4 years ago |
|
@zoltan Yes, this proved to ultimately be the problem. I us... In forum Hardware, firmware and software help |
4 years ago |
|
Wow...lots of great information here. Thanks! When I initia... In forum Hardware, firmware and software help |
4 years ago |
|
Sudden change in print quality... In forum Hardware, firmware and software help |
4 years ago |
|
Thanks! Turns out, Z Hop was already off. I took your advi... In forum General discussion, announcements and releases |
5 years ago |
|
How do I turn off Z-Hop? In forum General discussion, announcements and releases |
5 years ago |
