stuart.b4
stuart.b4
Group: Registered
Joined: 2017/09/25
Estimable Member
4
I wouldn't recommend the standard e3d heatbreak. I had one b...

In forum Assembly and first prints troubleshooting

1 month ago
It sounds like bearing failure to me in the video. Get your...

In forum Hardware, firmware and software help

2 months ago
@ak-1 Hi, I can't see the video. I recently had a sticky X a...

In forum Hardware, firmware and software help

2 months ago
The filament sensor should not need to be re-calibrated when...

In forum General discussion, announcements and releases

2 months ago
Temperatures are in Filament Settings

In forum General discussion, announcements and releases

2 months ago
It's difficult when you run into multiple issues to troubles...

In forum Assembly and first prints troubleshooting

4 months ago
There are going to be a lot of opinions coming your way, her...

In forum Assembly and first prints troubleshooting

4 months ago
...or just fix it for the price of 8 nyloc M3 nuts and some ...

In forum Hardware, firmware and software help

4 months ago
It does, to an extent. My bed had a low corner. The effect ...

In forum Hardware, firmware and software help

4 months ago
I highly recommend following this thread and doing this mod:

In forum Hardware, firmware and software help

4 months ago
Sorry, I'm having a hard time following the description of t...

In forum Hardware, firmware and software help

4 months ago
I recently got a new textured sheet for my Mk3 (white print)...

In forum Hardware, firmware and software help

4 months ago
Thanks, demagnetising hadn't crossed my mind!

In forum How do I print this? (Printing help)

4 months ago
ABS warping paranoia... magnets to the rescue?

In forum How do I print this? (Printing help)

4 months ago
My chief problems with the MMU2 can be considered to be that...

In forum Assembly and first prints troubleshooting

4 months ago
I've left small prints overnight and still had to deal with ...

In forum General discussion, announcements and releases

4 months ago
I suspect agitation in warm water, e.g. an ultrasonic cleane...

In forum General discussion, announcements and releases

4 months ago
Ability to "probe" down in Z until the nozzle touches the pr...

In forum General discussion, announcements and releases

12 months ago
This is all after my tweaking... A: Over 50 successful print...

In forum General discussion, announcements and releases

1 year ago
The MMU2S idler is supposed to move up and down a bit. When...

In forum Assembly and first prints troubleshooting

1 year ago
Page 1 / 10
Share:

Please Login or Register