|
Update: Since Firmware Version 4.0.3 the bed temperature won... In forum General discussion, announcements and releases |
4 years ago |
|
We had this problem, too. No only once. Also, a lot of other... In forum Hardware, firmware and software help |
4 years ago |
|
@littleneutrino I just wanted to post my settings here, sinc... In forum User mods - OctoPrint, enclosures, nozzles, ... |
4 years ago |
|
4.0.3 is officially released and verified by PR. No need to ... In forum General discussion, announcements and releases |
4 years ago |
|
Even if we are getting off topic, OctoPrint still works with... In forum General discussion, announcements and releases |
4 years ago |
|
I use to put some talcum powder (baby powder) on the PEI, wh... In forum General discussion, announcements and releases |
4 years ago |
|
Hi Folks, short update on this topic: First off all, tha... In forum Assembly and first prints troubleshooting |
4 years ago |
|
Thanks guys. This is truly helpful for everyone, who will de... In forum General discussion, announcements and releases |
4 years ago |
|
Selftest Wizard - Z-Axis In forum Assembly and first prints troubleshooting |
4 years ago |
|
Did anyone already installed the R2 parts? Especially for th... In forum General discussion, announcements and releases |
4 years ago |
|
When I look into my orders, newest stauts is always on top,... In forum General discussion, announcements and releases |
4 years ago |
|
Possibly, but on the other hand, the next black one w/o sens... In forum General discussion, announcements and releases |
4 years ago |
|
Not trolling, just ordered a black one w/o sensor eary enoug... In forum General discussion, announcements and releases |
4 years ago |
