stephan.k
stephan.k
Group: Registered
Joined: 2016/10/05
Reputable Member
5
Ja, ist normal, war bei mir auch so. Guck hier:

In forum Allgemeine Diskussion, Ankündigungen und Veröffentlichungen

2 years ago
Yeah, looks just like what mine did.. here., i found the old...

In forum Hardware, firmware and software help

2 years ago
I had a similar problem a while back, it looked liked my hot...

In forum Hardware, firmware and software help

2 years ago
I gotta ditto the issue with belt status. It's pointless.. B...

In forum Assembly and first prints troubleshooting

2 years ago
On the printer: Settings > Temperature > Nozzle ins...

In forum Assembly and first prints troubleshooting

2 years ago
The MK3 power supply is listed in the prusa shop You might...

In forum Assembly and first prints troubleshooting

2 years ago
I've tried a few different ones, yes.. Some seem to be bette...

In forum General discussion, announcements and releases

2 years ago
Use the shortest smooth rods in the package - if recall cor...

In forum Assembly and first prints troubleshooting

2 years ago
Schau mal hier, da bekommst die auch einzeln (M3x2 in A1 Ede...

In forum Hilfe zur Hardware, Firmware und Software

2 years ago
Just FYI, i have the same problem when trying to extrude 100...

In forum Hardware, firmware and software help

2 years ago
And this is after swapping the thermistor and how it used to...

In forum Others (Archive)

3 years ago
Re: Nozzle wont go over ~210°C

In forum Others (Archive)

3 years ago
Thanks all for your suggestions. As it turned out, it was a ...

In forum Others (Archive)

3 years ago
Eduard, sounds kinda like the classic "wrong side up during...

In forum Others (Archive)

3 years ago
Nozzle wont go over ~210°C

In forum Others (Archive)

3 years ago
Unfortunately, I am on a different PIN plus I need Z-Height ...

In forum Improvements (Archive)

3 years ago
I don't think they ship that ring together with the tube. I ...

In forum Prusa i3 kit (Archive)

3 years ago
Classic cause for "2 middle holes don't fit" is: accidental ...

In forum Prusa i3 kit (Archive)

3 years ago
That black ring seen around the PTFE tube, usually you can p...

In forum Prusa i3 kit (Archive)

3 years ago
I am not sure what else besides LM8UU you expected to see on...

In forum Others (Archive)

3 years ago
Page 1 / 21
Share:

Please Login or Register