|
Considering the z index isn't part of the build plate, I'd c... Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
Continued "some problem encountered, Z leveling enforced"... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
Turned out the wires from the MMU board weren't actually con... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
MMU2S won't turn on after upgrading Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
I haven't checked under the board, but it doesn't seem to be... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
yup, I did and no, or at times very little, power from the b... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
I'm gonna take it that no one has anything to add and that t... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
Yes. Several times as I tested other things. Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
Heat Bed pre heat error - time for a new board? Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
It seams the plug on the ribbon probably wasn't seated right... Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
w00t!!
So for the heck of it, I turned off the printer, remo... Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
failed flashing. I can't take a look at the log, though, for... Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
I haven't tried reflashing. If it's not showing up for octop... Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
Since I only unplugged one of the ribbons from the LCD, I'm ... Dans le forum Hardware, firmware and software help |
il y a 6 years |
|
Ooops... Might have fried my Rambo electronics Dans le forum Hardware, firmware and software help |
il y a 6 years |
