Prusa3D Forum

Notifications

Clear all

simon.p

Group: Registered

Joined: 2016/09/22

Trusted Member

	it prints fine, sticked very good to a glue covered bed. the... In forum Others (Archive)	7 years ago
	your nozzle is way too high. have you done your live-z adjus... In forum Prusa i3 kit (Archive)	7 years ago
	as there will always be a time lapse between between the mea... In forum Improvements (Archive)	7 years ago
	Since you really care about averge diameter you would need t... In forum Improvements (Archive)	7 years ago
	Sorry for you bad experience. Not trying to put salt on ope... In forum Others (Archive)	7 years ago
	your nozzle distance to bed is too high. adjust z. if you ar... In forum Prusa i3 kit (Archive)	7 years ago
	I have the same exact issue. Switching to High Powered mode ... In forum Prusa i3 kit (Archive)	7 years ago
	➡ the clearance of the bearings always induced a littl... In forum Hardware, firmware and software help	7 years ago
	Did you contact support? I think they are online 24h. This... In forum Others (Archive)	7 years ago
	So this has not even been printed with an Original Prusa i3? In forum Print tips (Archive)	7 years ago
	Sounds and looks to me like the y axis starts resonating and... In forum Assembly and first prints troubleshooting	7 years ago
	maybe relevant In forum Print tips (Archive)	7 years ago
	I tried to read the last post but that was quite confusing. ... In forum Others (Archive)	7 years ago
	I would have assumed that mesh bed leveling should take care... In forum Others (Archive)	7 years ago
	@simon.p As to whether rattling is a failure or not, I'd arg... In forum Hardware, firmware and software help	7 years ago
	Thanks everyone for a really useful thread. My prebuilt mk2... In forum Hardware, firmware and software help	7 years ago
	If you are only printing PLA then it should not be an issue.... In forum Prusa i3 kit (Archive)	7 years ago
	My solution to this problem... In forum Improvements (Archive)	7 years ago
	Personally I would rather have a working multi-material prin... In forum Software (Archive)	7 years ago
	A simple search would bring you to this You possibly have ... In forum Others (Archive)	7 years ago

Page 1 / 5 Next

Forum Statistics

535 Forums

59.4 K Topics

425.8 K Posts

17 Online

63.8 K Members

Latest Post: Restzeitanzeige bis zum Filamentwechsel Our newest member: GreenyMeanie Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed