|
Still nothing here. So much for "Late November - Early Dece... In forum General discussion, announcements and releases |
5 years ago |
|
Wouldn't you have thought that they'd have experienced this ... In forum General discussion, announcements and releases |
5 years ago |
|
Just had a conversation with Chat.
Apparently the latest vo... In forum General discussion, announcements and releases |
5 years ago |
|
I still haven't had the option of getting mine from my order... In forum General discussion, announcements and releases |
5 years ago |
|
And what a waste of time that turned out to be. Still an un... In forum General discussion, announcements and releases |
5 years ago |
|
I spoke to Prusa support a couple of weeks ago and they said... In forum General discussion, announcements and releases |
5 years ago |
|
They will print fine, they’re just not ‘tuned’ specifically ... In forum Others (Archive) |
6 years ago |
|
The link is in the first post.
This is what I printed to ... In forum Others (Archive) |
6 years ago |
|
Are you saying the 16T idler is smaller than the smooth one ... In forum Others (Archive) |
6 years ago |
|
I can happily say that with the smaller diameter 16 tooth id... In forum Others (Archive) |
6 years ago |
|
With the bearings on the toothed idler being flush with the ... In forum Others (Archive) |
6 years ago |
|
Sorry, I did have a quick scan through but I missed the pos... In forum General discussion, announcements and releases |
6 years ago |
|
I'm still trying print without OctoPi, but shifted layers ar... In forum General discussion, announcements and releases |
6 years ago |
|
Makes sense to heat the bed first and nozzle second. That w... In forum Hardware, firmware and software help |
6 years ago |
|
I'd guess that it's because it serves no purpose at that poi... In forum Others (Archive) |
6 years ago |
|
I wouldn't expect a Mk3 specific slicing of it. The gcode s... In forum Others (Archive) |
6 years ago |
|
Head to here
You should have a link to Live Chat at the bo... In forum Others (Archive) |
6 years ago |
|
I also did the factory reset and fresh calibration prior to ... In forum General discussion, announcements and releases |
6 years ago |
|
Sometimes I heard very hard step from motors. Without conseq... In forum General discussion, announcements and releases |
6 years ago |
|
Have you got it running in 'Stealth' mode ?
If mine is in S... In forum Others (Archive) |
6 years ago |
