SeattleDavid
SeattleDavid
Group: Registered
Joined: 2020/01/09
Estimable Member
4
Much of where I am having problems is that I am doing very d...

In forum How do I print this? (Printing help)

1 week ago
Nobody owes me any answers, you are correct. We are all free...

In forum General discussion, announcements and releases

2 weeks ago
Bad bad typo on my part. Embarrassing. 0.6mm profile and 0.6...

In forum How do I print this? (Printing help)

2 weeks ago
@gnat Yes, when the MMU starts reeling the filament black th...

In forum General discussion, announcements and releases

2 weeks ago
The filament goes all the way down into the heater assembly,...

In forum General discussion, announcements and releases

2 weeks ago
Any guess whether the Prusa Mini will provide the advertised...

In forum Hardware, firmware and software help

3 weeks ago
Anybody?

In forum General discussion, announcements and releases

3 weeks ago
I can certainly spend my day becoming a research associate. ...

In forum How do I print this? (Printing help)

3 weeks ago
It is also possible (even likely) that I did read the manual...

In forum How do I print this? (Printing help)

3 weeks ago
Gaps between printed traces: Why & How to eliminate?

In forum How do I print this? (Printing help)

3 weeks ago
I am generally quite meticulous. Here is a clean sheet with ...

In forum How do I print this? (Printing help)

3 weeks ago
Here is a photo showing the clear PETG bunching up on the no...

In forum How do I print this? (Printing help)

3 weeks ago
Is clear PETG particularly difficult?

In forum How do I print this? (Printing help)

3 weeks ago
I truly hate the MMU2S: "MMULoad failure"

In forum General discussion, announcements and releases

3 weeks ago
That sounds like an interesting option. I did see it, but th...

In forum How do I print this? (Printing help)

3 weeks ago
Don't Travel over small holes?

In forum How do I print this? (Printing help)

3 weeks ago
There does still remain this really odd, quite unexplainable...

In forum How do I print this? (Printing help)

3 weeks ago
Yes! Changing Elephant Foot Compensation to 0.0 fixed layer ...

In forum How do I print this? (Printing help)

3 weeks ago
I will. This is a good suggestion!

In forum How do I print this? (Printing help)

3 weeks ago
Most of the “errors” are unavoidable. Which is why some face...

In forum How do I print this? (Printing help)

3 weeks ago
Page 1 / 6
Share:

Please Login or Register