Prusa3D Forum

Notifications

Clear all

Rutilate

Group: Registered

Joined: 2016/05/29

Trusted Member

	If that is the case would it be best to add M221 S100 in the... In forum Others (Archive)	6 years ago
	Two things you can try: ank the top of the z frame forward. ... In forum Others (Archive)	6 years ago
	Folks, I'm not sure that the overextrusion has been resolve... In forum Others (Archive)	6 years ago
	Ringing in Y-axis In forum Others (Archive)	6 years ago
	Turning down the part fan only ameliorates the symptom--it d... In forum Others (Archive)	7 years ago
	Is there a better quality belt upgrade? In forum Others (Archive)	8 years ago
	curtis.b I totally agree with your comment above. And shown ... In forum Others (Archive)	8 years ago
	If you export out your FFF config and edit the file (in some... In forum General discussion, announcements and releases	8 years ago
	Hotend temp fluctuations-~6 degrees In forum Others (Archive)	8 years ago
	These alignment sticks are fantastic. Great job. I was cons... In forum Improvements (Archive)	8 years ago
	This reference should be quite enough: 😉 😀 With a dire... In forum Others (Archive)	8 years ago
	If others are interested in participating, I am setting up a... In forum General discussion, announcements and releases	8 years ago
	The RC4 version of S3D has a default first layer set at 100%... In forum General discussion, announcements and releases	8 years ago
	This has been discussed before. I've heard this item doesn'... In forum Others (Archive)	8 years ago
	Make sure bed level correction is reset before attempting ca... In forum Others (Archive)	8 years ago
	Can Octoprint connect to MK2 at 250k baud rate? In forum Others (Archive)	8 years ago
	Ask and ye shall receive. I actually just asked PR support ... In forum Others (Archive)	8 years ago
	Where is the Y-motor stabilizer STL? In forum Others (Archive)	8 years ago
	Yes, 3.0.8 will allow extruder speeds of 120mm/sec; I think ... In forum Others (Archive)	8 years ago
	I have no idea why firmware retraction (G10/G11/M207) has be... In forum Others (Archive)	8 years ago

Page 1 / 5 Next

Forum Statistics

535 Forums

59.4 K Topics

426.2 K Posts

20 Online

63.9 K Members

Latest Post: Custom Dry Box / Work Bench Our newest member: Charles Jacques Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed