Activity
 
Notifications
Clear all
ron
ron
Group: Registered
Joined: 2016/10/20
Estimable Member
4
Here the diagram of the selector which is different from the...

In forum How do I print this? (Printing help)

11 months ago
There is no temp on the Eibos easydry, only a selector. I se...

In forum How do I print this? (Printing help)

11 months ago
I just made some extrusion multiplier calibration for the PC...

In forum How do I print this? (Printing help)

1 year ago
When I talked about PCCF, it was indeed Prusament PC Blend w...

In forum How do I print this? (Printing help)

1 year ago
I choose PCCF over PACF because I didn't want to struggle wi...

In forum How do I print this? (Printing help)

1 year ago
I too had a bad first experience with that 1.04 default extr...

In forum General discussion, announcements and releases

1 year ago
I built a Voron 350 2 years ago because I was thinking Prusa...

In forum General discussion, announcements and releases

2 years ago
It would have been Revo time for me too if I hadn't some Bon...

In forum Hardware, firmware and software help

2 years ago
I was thinking I could help. As soon as it turns, it should ...

In forum Hardware, firmware and software help

2 years ago
:thinking_face:Maybe you tighten too much. E3D says 3NM torq...

In forum Hardware, firmware and software help

2 years ago
You need a 16mm Wrench to keep the heatblock in place when t...

In forum Hardware, firmware and software help

2 years ago
OK, j'aurais aimé la vendre un peu plus cher. Oui, ca prend ...

In forum Discussion générale, annonces et nouveautés

2 years ago
Finalement je poursuis la discussion ici car on m'y a topé.F...

In forum Discussion générale, annonces et nouveautés

2 years ago
Nylon: je passe mon chemin tant que je n'ai pas de Printdry....

In forum Impressions fantastiques

2 years ago
Je n'ai pas réussi à savoir où il sont implantés.J'ai une tr...

In forum Impressions fantastiques

2 years ago
I have a new version of the gcodes but not yet compatible wi...

In forum General discussion, announcements and releases

2 years ago
OK. Je vais écrire qquechose de propre sur l'autre sujet.

In forum Discussion générale, annonces et nouveautés

2 years ago
Merci. Je ne connaissais pas ICE. Ils ont un soucis de certi...

In forum Impressions fantastiques

2 years ago
C'est quelle ref de PC-ABS?

In forum Impressions fantastiques

2 years ago
MMUS2S a vendre

In forum Discussion générale, annonces et nouveautés

2 years ago
Page 1 / 11
Share: