robin.a
robin.a
Group: Registered
Joined: 2018/02/16
Estimable Member
4
A bit more info for you here. I started with hairspray as a...

In forum General discussion, announcements and releases

3 weeks ago
@gary-a2 You will see a blue trace line on the sliced image ...

In forum PrusaSlicer

11 months ago
once sliced you can go to the bottom and show the travel of ...

In forum PrusaSlicer

11 months ago
Not sure if this is what your trying to do. You can set a p...

In forum General discussion, announcements and releases

11 months ago
I believe the bearings are covered here

In forum Hardware, firmware and software help

11 months ago
It’s not sandpaper

In forum Assembly and first prints troubleshooting

12 months ago
Get some Scotch brite pads. You may need the fine ones for t...

In forum Assembly and first prints troubleshooting

12 months ago
The PINDA as said only works on the steel sheet its self. Th...

In forum Print tips (Archive)

1 year ago
With mine i just select preheat setting for the filament typ...

In forum Assembly and first prints troubleshooting

1 year ago
It looks like your printing on the textured build sheet? If ...

In forum Print tips (Archive)

1 year ago
Check and see if you have the branded or none branded bearin...

In forum Hardware, firmware and software help

1 year ago
Misumi bearings if bought from a supplier will normally come...

In forum Assembly and first prints troubleshooting

1 year ago
Think the low temp is about 170degrees may be a bit more. Pr...

In forum How do I print this? (Printing help)

1 year ago
Eccellent answer from bobstro above covers most of what you ...

In forum How do I print this? (Printing help)

1 year ago
I only use the printed type bearing holders now. The U bolts...

In forum Improvements (Archive)

1 year ago
If you start hearing a clunk or thud as the Y xais moves its...

In forum Assembly and first prints troubleshooting

1 year ago
for a mod to the Y axis bearings i can recoment this type of...

In forum Assembly and first prints troubleshooting

1 year ago
Is the power fail on the print to total? You should not get...

In forum Assembly and first prints troubleshooting

1 year ago
A few questions What slicer are you using? What settings are...

In forum Assembly and first prints troubleshooting

1 year ago
What is the make and type of filament and is it old or new

In forum Hardware, firmware and software help

1 year ago
Page 1 / 8
Share:

Please Login or Register