|
Please don't take this the wrong way. If you replace the E3D... In forum General discussion, announcements and releases |
5 years ago |
|
It can't work with OctoPrint. The Pi reboots after power ret... In forum Hardware, firmware and software help |
5 years ago |
|
Re: How to use: 3D Printer Filament Detection Sensor Run-out... In forum Hardware, firmware and software help |
5 years ago |
|
The MK3S non crap sensor doesn't detect jams. In forum Hardware, firmware and software help |
5 years ago |
|
This works well, uses the crap sensor and is simple to make. In forum Hardware, firmware and software help |
5 years ago |
|
I printed some parts from clear filament with the original c... In forum Hardware, firmware and software help |
5 years ago |
|
I opted for the PEI sheet. Also bought one with the survey v... In forum General discussion, announcements and releases |
5 years ago |
|
I'm very happy with this one. In forum General discussion, announcements and releases |
5 years ago |
|
I had the same problem and solved it in S3D the same way. In forum General discussion, announcements and releases |
6 years ago |
|
I had similar problems. Prusa replaced the console and all i... In forum Hardware, firmware and software help |
6 years ago |
|
Power failure In forum Hardware, firmware and software help |
6 years ago |
|
I had the same problem and they sent me a new display which ... In forum Hardware, firmware and software help |
6 years ago |
|
I just glued 12 magnets back in using high temp silicone gas... In forum Hardware, firmware and software help |
6 years ago |
|
After having problems with the PINDA cable, I replaced the s... In forum General discussion, announcements and releases |
6 years ago |
|
What filament? I had the same problem with a very shiny fila... In forum Hardware, firmware and software help |
6 years ago |
|
That looks like Prusa PLA. I had similar problems and solved... In forum General discussion, announcements and releases |
6 years ago |
|
My cable failed a while ago and I repaired it. Failed again ... In forum Hardware, firmware and software help |
6 years ago |
|
I've given up on Prusa PLA. Every jam I've had is with it an... In forum Hardware, firmware and software help |
6 years ago |
|
Yep In forum General discussion, announcements and releases |
6 years ago |
|
I turned it off some time ago. Mt prints improved significan... In forum Hardware, firmware and software help |
6 years ago |
