Activity
 
robee
robee
Group: Registered
Joined: 2020/03/08
Trusted Member
3
Gosh this looks... not good! Thank you for the images. I thi...

In forum Assembly and first prints troubleshooting

2 days ago
Slice the model as usual and save the gcode. Then add a laye...

In forum Hardware, firmware and software help

3 days ago
@connercbc No they didn't 🙁

In forum Assembly and first prints troubleshooting

3 days ago
Thank you! Hopefully I can answer your questions... 1) I wan...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 days ago
I haven't tried TPU, but PLA worked so perfectly I think it ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 weeks ago
I have had my Bondtech for about four months now, and the tu...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 weeks ago
I think to start with, to see if this helps, a metal clip on...

In forum General discussion, announcements and releases

3 weeks ago
I don't know what is causing it, or how to mitigate it, but ...

In forum General discussion, announcements and releases

4 weeks ago
I didn't mind the PLA fumes for the first few weeks, and the...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 weeks ago
I built my enclosure because I found the PLA fumes were irri...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 weeks ago
This might help people tune filaments: And the temperature ...

In forum How do I print this? (Printing help)

4 weeks ago
I only use two gcode scripts in OctoPrint, one for raising t...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
This could be under-extrusion that you might need to fix by ...

In forum Hardware, firmware and software help

1 month ago
I have exactly the same settings as @vookimedlo. The -4 for ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
I think the most important thing to be ware of is that the P...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
I doubt the circuit design on the Prusa printer controller w...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
I would strongly recommend getting RGBW LEDs, the white colo...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
I have been using my Bondtech for a few months now, and on t...

In forum General discussion, announcements and releases

1 month ago
I tightened my nozzle just in case, and cleaned it, but I wo...

In forum Hardware, firmware and software help

2 months ago
I thought this was what caused it, but I'm not sure why they...

In forum Hardware, firmware and software help

2 months ago
Page 1 / 4
Share:

Please Login or Register