Activity
 
rob.l6
rob.l6
Group: Registered
Joined: 2017/06/27
Honorable Member
1
I doubt such a thing exists. Each component (sensors, motors...

In forum General discussion, announcements and releases

9 months ago
Kit is pretty easy to build. Excellent instructions are avai...

In forum General discussion, announcements and releases

10 months ago
Kit is pretty easy to build. Excellent instructions are avai...

In forum General discussion, announcements and releases

10 months ago
You could just use an off the shelf remote wifi switch (like...

In forum Hardware, firmware and software help

10 months ago
What exactly are you trying to achieve? Some sort of remote ...

In forum Hardware, firmware and software help

10 months ago
It's the royal "we" you keep using. So you aren't represent...

In forum General discussion, announcements and releases

10 months ago
Rob, do you represent Prusa in this? Why would I represe...

In forum General discussion, announcements and releases

10 months ago
If Prusa (@Rob) believes the bearings that ship with printer...

In forum General discussion, announcements and releases

10 months ago
But does this apply for the bearings PR use, and in this env...

In forum General discussion, announcements and releases

10 months ago
Probably the largest two mistakes Prusa makes is not demandi...

In forum General discussion, announcements and releases

10 months ago
Mmmm, In terms of nozzles, we have been using "craptastic" f...

In forum Assembly and first prints troubleshooting

10 months ago
Not to make light of the OPs issues, but google translate de...

In forum General discussion, announcements and releases

10 months ago
Sorry, you can't be trusted. 😆 😈

In forum General discussion, announcements and releases

10 months ago
There are two sides to each coin, and it's nonsensical to ge...

In forum General discussion, announcements and releases

10 months ago
That may be the case but I'm paying interest on the charges ...

In forum General discussion, announcements and releases

10 months ago
Yes.

In forum User mods - OctoPrint, enclosures, nozzles, ...

10 months ago
i was on matterhackers and found this in the newly added sec...

In forum User mods - OctoPrint, enclosures, nozzles, ...

10 months ago
I've checked the bed with a level and ruler and don't see an...

In forum Assembly and first prints troubleshooting

10 months ago
Yes, two most common causes are z offset being set too low, ...

In forum Assembly and first prints troubleshooting

10 months ago
PC just seems like a nuisance to print with also it makes po...

In forum Assembly and first prints troubleshooting

10 months ago
Page 1 / 26
Share:

Please Login or Register