Notifications
Clear all
rmilyard
rmilyard
Group: Registered
Joined: 2019/04/20
Active Member
1
Anyone?

In forum PrusaSlicer

9 months ago
Error with PS 2.6 and Voron

In forum PrusaSlicer

9 months ago
MMU2S printed parts

In forum General discussion, announcements and releases

4 years ago
@antimix Tried those settings and changed nothing else. Loa...

In forum General discussion, announcements and releases

5 years ago
@antimix Filament is PLA. Attachment removed

In forum General discussion, announcements and releases

5 years ago
So better. Had failed load 3 times but much better. Tips sti...

In forum General discussion, announcements and releases

5 years ago
@antimix Single color seem very good. No issues when printi...

In forum General discussion, announcements and releases

5 years ago
@david-a66 I have custom firmware from vertigo. So e-steps ...

In forum General discussion, announcements and releases

5 years ago
I am going to try with my MK3S+MMU2S with Bondtech Mosquito ...

In forum General discussion, announcements and releases

5 years ago
I was told of set to E600 for Bondtech extruder motor.

In forum General discussion, announcements and releases

5 years ago
Thanks. I did double check and valves are stored.

In forum General discussion, announcements and releases

5 years ago
I emailed them but closed right now. Hard with time diff. ...

In forum General discussion, announcements and releases

5 years ago
Nozzle dragging I think MK3s

In forum General discussion, announcements and releases

5 years ago
Printer should be here tomorrow!

In forum General discussion, announcements and releases

5 years ago
So if use USB to connect Pi 3b+ to the MK3S I am guessing yo...

In forum General discussion, announcements and releases

5 years ago
Just purchased MK3S last night and want to prepair

In forum General discussion, announcements and releases

5 years ago
Share: