rmilyard
rmilyard
Group: Registered
Joined: 2019/04/20
Active Member
1
MMU2S printed parts

In forum General discussion, announcements and releases

10 months ago
@antimix Tried those settings and changed nothing else. Loa...

In forum General discussion, announcements and releases

11 months ago
@antimix Filament is PLA.  Capture.JPG

In forum General discussion, announcements and releases

11 months ago
So better. Had failed load 3 times but much better. Tips sti...

In forum General discussion, announcements and releases

11 months ago
@antimix Single color seem very good. No issues when printi...

In forum General discussion, announcements and releases

11 months ago
@david-a66 I have custom firmware from vertigo. So e-steps ...

In forum General discussion, announcements and releases

11 months ago
I am going to try with my MK3S+MMU2S with Bondtech Mosquito ...

In forum General discussion, announcements and releases

11 months ago
I was told of set to E600 for Bondtech extruder motor.

In forum General discussion, announcements and releases

1 year ago
Thanks. I did double check and valves are stored.

In forum General discussion, announcements and releases

1 year ago
I emailed them but closed right now. Hard with time diff. ...

In forum General discussion, announcements and releases

1 year ago
Nozzle dragging I think MK3s

In forum General discussion, announcements and releases

1 year ago
Printer should be here tomorrow!

In forum General discussion, announcements and releases

1 year ago
So if use USB to connect Pi 3b+ to the MK3S I am guessing yo...

In forum General discussion, announcements and releases

1 year ago
Just purchased MK3S last night and want to prepair

In forum General discussion, announcements and releases

1 year ago
Share:

Please Login or Register