richard.l
richard.l
Group: Moderator
Joined: 2015/10/29
Title: Member Moderator
1
@PJR is the KISS guru. Hopefully he sees this thread.

In forum Cura, Simplify3D, Kisslicer, ...

1 week ago
Purge Mech

In forum Hardware, firmware and software help

2 weeks ago
@david-w89 No, Layer 1 temp is for Layer 1 of the print. If ...

In forum PrusaSlicer

2 months ago
@david-w89 That should be easy enough. Create another filame...

In forum PrusaSlicer

2 months ago
I believe it is only possible with version 2.1 of PrusaSlice...

In forum PrusaSlicer

2 months ago
RE: HELP no instructions

In forum Assembly and first prints troubleshooting

2 months ago
Unfortunately, it hasn't been implemented. It has been reque...

In forum PrusaSlicer

3 months ago
I know many of the Print Profiles created by Chris Warcocki ...

In forum Assembly and first prints troubleshooting

3 months ago
Easy, in the Print Settings tab select Spiral Vase mode.

In forum How do I print this? (Printing help)

3 months ago
Looking at the picture, it seems you removed the PEI sheet. ...

In forum Hardware, firmware and software help

4 months ago
I just don't get it. You have a problem, come into the forum...

In forum Assembly and first prints troubleshooting

4 months ago
There was something wrong with the model. I ran it through t...

In forum PrusaSlicer

4 months ago
Can you zip up the stl file and upload it here so that other...

In forum PrusaSlicer

4 months ago
I wouldn't increase the infill with a modifier for a screw h...

In forum PrusaSlicer

4 months ago
Wouldn't it be beneficial to use Variable layer heights? I c...

In forum Assembly and first prints troubleshooting

4 months ago
And...the processor passes the additional amount taken by Ap...

In forum General discussion, announcements and releases

5 months ago
I must say, I missed that it was quoting you. Somebody had t...

In forum General discussion, announcements and releases

5 months ago
Which post are you talking about? If it is Tim's, well, he i...

In forum General discussion, announcements and releases

5 months ago
Not to get too deep into this, but what you have said is not...

In forum General discussion, announcements and releases

5 months ago
Page 1 / 36
Share:

Please Login or Register