|
I had this issue occasionally as well. Re-slicing and upload... In forum User mods - OctoPrint, enclosures, nozzles, ... |
4 years ago |
|
At first glance it looks like an "under extrusion" issue. As... In forum Assembly and first prints troubleshooting |
4 years ago |
|
There are 2 major things that can cause your prints not to s... In forum Assembly and first prints troubleshooting |
4 years ago |
|
The transition to the smaller diameter could be a number of ... In forum How do I print this? (Printing help) |
4 years ago |
|
I had similar issues and turns out it was because of the bed... In forum Assembly and first prints troubleshooting |
4 years ago |
|
There is a setting that Neophyl mentioned which is minimal l... In forum How do I print this? (Printing help) |
4 years ago |
|
You can also try standing the model on its tail, this would ... In forum How do I print this? (Printing help) |
4 years ago |
|
Your multiplier is how much material is actually being extru... In forum How do I print this? (Printing help) |
4 years ago |
|
I had similar issue that were caused by the Bondtech gears i... In forum Assembly and first prints troubleshooting |
4 years ago |
|
Your first layer might be a little low, I would try to raise... In forum Assembly and first prints troubleshooting |
4 years ago |
|
This was a surprising issue for me as well. As far as removi... In forum General discussion, announcements and releases |
4 years ago |
|
I would definitely try to print with a Brim as well. In addi... In forum How do I print this? (Printing help) |
4 years ago |
|
I had this same issue, for me it turned out the filament was... In forum Assembly and first prints troubleshooting |
4 years ago |
|
Very good write up, thanks for sharing your experience! I ... In forum Print tips (Archive) |
5 years ago |
|
Surprised this wasnt mentioned, but my 2 are Bed Visulizer, ... In forum User mods - OctoPrint, enclosures, nozzles, ... |
5 years ago |
|
ABS is a pain to print with, but here are few things you nee... In forum General discussion, announcements and releases |
5 years ago |
