RHDreambox
RHDreambox
Group: Registered
Joined: 2017/10/23
Prominent Member
2
Some images showing your problem would be great to see.

In forum Assembly and first prints troubleshooting

1 month ago
Your problem is quite common for beginners.The causes are us...

In forum Assembly and first prints troubleshooting

2 months ago
Hi @Ireal2That print doesn't look good at all. It is not an ...

In forum Assembly and first prints troubleshooting

2 months ago
If you have previously done a correct mounting of PINDA and ...

In forum Assembly and first prints troubleshooting

2 months ago
More Fan duct's...

In forum Hardware, firmware and software help

2 months ago
Isopropyl is not sufficient for a rough cleaning of the text...

In forum How do I print this? (Printing help)

2 months ago
If you reassembled the extruder then you will need to do a n...

In forum How do I print this? (Printing help)

2 months ago
@mgruenlohWhat happens if you make the fan bracket of PLA or...

In forum General discussion, announcements and releases

2 months ago
There may be some problems with getting the filament to adhe...

In forum How do I print this? (Printing help)

2 months ago
If you hear a humming noise when the X or Y axis reaches its...

In forum Assembly and first prints troubleshooting

2 months ago
No your smooth plate is not ruined. It is quite common for s...

In forum Hardware, firmware and software help

2 months ago
The screws (M3x10) should align evenly with the back of the ...

In forum Assembly and first prints troubleshooting

2 months ago
You do not write what layer height you intend to use, but an...

In forum How do I print this? (Printing help)

2 months ago
@makak007 Maybe you should try one of these "problem solvers...

In forum General discussion, announcements and releases

2 months ago
Your detail should definitely be placed with the large surfa...

In forum How do I print this? (Printing help)

2 months ago
These small air bubbles are quite common and there is nothin...

In forum Hardware, firmware and software help

3 months ago
Can you view a picture where we can see what the first layer...

In forum Assembly and first prints troubleshooting

3 months ago
If I understand you correctly, you adjust the Z level to mak...

In forum Assembly and first prints troubleshooting

3 months ago
OK @ dandockery02 you can start by turning the toothed drive...

In forum Assembly and first prints troubleshooting

3 months ago
Page 1 / 40
Share:

Please Login or Register