|
Worth checking I guess. I assumed that since it was in MMU e... In forum Hardware, firmware and software help |
4 months ago |
|
I installed the main board firmware that was included in the... In forum Hardware, firmware and software help |
4 months ago |
|
MMU2S not recognized after firmware 3.13.2 (3.0.1) upgrade In forum Hardware, firmware and software help |
4 months ago |
|
I tried the chat for a short while last night - but the wait... In forum Hardware, firmware and software help |
4 years ago |
|
While I like the newer extruder design, after upgrading one ... In forum Hardware, firmware and software help |
4 years ago |
|
I had that issue with the modem manager the last time I upda... In forum Hardware, firmware and software help |
4 years ago |
|
for me, it failed using a Ubuntu-Based laptop. every time it... In forum Hardware, firmware and software help |
4 years ago |
|
wish i could say that. mine reports NA in the console now. a... In forum Hardware, firmware and software help |
4 years ago |
|
updating MMU2 firmware from 1.0.5 to 1.0.6 and restoring bri... In forum Hardware, firmware and software help |
4 years ago |
|
and attempting to get back to 1.0.5 leaves me with this: vrd... In forum Hardware, firmware and software help |
4 years ago |
|
folllowing that guide - now i'm bricked. one thing i found... In forum Hardware, firmware and software help |
4 years ago |
|
actually i think it just bricked mine. i've been trying to g... In forum Hardware, firmware and software help |
4 years ago |
|
why does bed leveling probe a point twice? In forum Hardware, firmware and software help |
5 years ago |
|
XYZ Calibration failed, check axes In forum Assembly and first prints troubleshooting |
5 years ago |
